Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Kuriyama, Yasutoshi*; Iwashita, Yoshihisa*; Hirota, Katsuya*; Hayano, Hitoshi*; Fuwa, Yasuhiro
Proceedings of 16th Annual Meeting of Particle Accelerator Society of Japan (Internet), p.32 - 35, 2019/10
Research and development of gradient enhancement of superconducting RF accelerating cavity is carried out by accelerator research institute in the world, but defects on the cavity surface limit accelerating electric field. Therefore, development of "Inside inspection system for superconducting accelerated cavity" that optically visualizes the state of the inner surface of the superconducting cavity has been carried out, and results have been achieved. In this research, we apply image processing technology that has developed remarkably in recent years to the internal inspection system, and advanced the defect recognition method. Extraction of depth information and image synthesis were performed from images obtained with different focal positions with the camera for internal surface inspection. Also, by performing pattern recognition processing on the images, automatic detection of defects has become possible. By integrating these techniques into the cavity inner surface inspection system, it becomes possible to shorten the scan time for defect search and acquire the defect shape.
Hirano, Koichiro; Kondo, Yasuhiro; Kawane, Yusuke; Shinozaki, Shinichi; Miura, Akihiko; Morishita, Takatoshi; Sawabe, Yuki; Sugimura, Takashi*; Naito, Fujio*; Fang, Z.*; et al.
Proceedings of 12th Annual Meeting of Particle Accelerator Society of Japan (Internet), p.944 - 947, 2015/09
Two RF-deflecting cavities as a chopper and a beam scraper have been used in the MEBT1 between a 324 MHz RFQ and a 50-MeV DTL of the J-PARC Linac. We replaced with a newly fabricated RF chopper to decrease beam loss for the operation with 50 mA. We installed two new scrapers to absorb the higher power of the deflected beam by the RF chopper. This paper describes the RF chopper system and beam irradiation test results of the scraper.
Ouchi, Nobuo; Akaoka, Nobuo*; Asano, Hiroyuki*; Chishiro, Etsuji; Namekawa, Yuya*; Suzuki, Hiroyuki*; Ueno, Tomoaki*; Noguchi, Shuichi*; Kako, Eiji*; Ouchi, Norihito*; et al.
Proceedings of 4th International Workshop on the Utilisation and Reliability of High Power Proton Accelerators, p.175 - 183, 2005/11
no abstracts in English
Hori, Toshihiko*; Chishiro, Etsuji; Yamazaki, Masayoshi*; Suzuki, Hiroyuki*; Hasegawa, Kazuo
Heisei-16-Nendo Osaka Daigaku Sogo Gijutsu Kenkyukai Hokokushu (CD-ROM), 4 Pages, 2005/03
no abstracts in English
Hasegawa, Kazuo; Ouchi, Nobuo; Chishiro, Etsuji; Kako, Eiji*; Noguchi, Shuichi*; Ouchi, Norihito*; Shishido, Toshio*; Tsuchiya, Kiyosumi*
Proceedings of 34th ICFA Advanced Beam Dynamics Workshop on High Power Superconducting Ion, Proton and Multi-Species Linacs (HPSL 2005) (Internet), 5 Pages, 2005/00
no abstracts in English
Kabumoto, Hiroshi; Takeuchi, Suehiro; Matsuda, Makoto; Nakanoya, Takamitsu
Dai-17-Kai Tandemu Kasokuki Oyobi Sono Shuhen Gijutsu No Kenkyukai Hokokushu, p.135 - 137, 2004/06
no abstracts in English
Kako, Eiji*; Noguchi, Shuichi*; Shishido, Toshio*; Asano, Hiroyuki*; Chishiro, Etsuji; Suzuki, Hiroyuki*; Hori, Toshihiko*; Yamazaki, Masayoshi*
Proceedings of 28th Linear Accelerator Meeting in Japan, p.324 - 326, 2004/06
no abstracts in English
Matsuda, Makoto; Takeuchi, Suehiro; Tsukihashi, Yoshihiro; Horie, Katsuzo; Ouchi, Isao; Hanashima, Susumu; Abe, Shinichi; Ishizaki, Nobuhiro; Tayama, Hidekazu; Nakanoya, Takamitsu; et al.
Dai-17-Kai Tandemu Kasokuki Oyobi Sono Shuhen Gijutsu No Kenkyukai Hokokushu, p.1 - 4, 2004/00
no abstracts in English
Hasegawa, Kazuo; High-intensity Proton Accelerator Linac Group
Proceedings of 28th Linear Accelerator Meeting in Japan, p.66 - 68, 2003/08
no abstracts in English
Ouchi, Nobuo; Akaoka, Nobuo*; Asano, Hiroyuki*; Chishiro, Etsuji; Hasegawa, Kazuo; Takeda, Osamu; Yoshikawa, Hiroshi; Matsuoka, Masanori*; Otani, Toshihiro*; Kako, Eiji*; et al.
Proceedings of 11th International Conference on Nuclear Engineering (ICONE-11) (CD-ROM), 6 Pages, 2003/04
no abstracts in English
Ao, Hiroyuki; Hayashizaki, Noriyosu*; Paramonov, V.*
Proceedings of 21st International Linear Accelerator Conference, p.82 - 84, 2003/00
Annular Coupled Structure (ACS) has been developed for the 190-400MeV coupled-cavity linac of the JAERI/KEK joint project. Design optimization of the ACS cavity has nearly been completed using 2D and 3D codes. In parallel with the numerical analyses, half-scale aluminum models were fabricated to confirm the numerical results. The cold-model tests also aim to finish the detailed design taking mass production procedures into account. Especially, the machining and the tuning procedures are examined in detail from the viewpoint of cost reduction and quality management. The results of the model tests are presented with those of other recent R&D works on ACS, which include fabrication R&D performed with full-scale models.
Ao, Hiroyuki; Hayashizaki, Noriyosu*
Proceedings of 27th Linear Accelerator Meeting in Japan, p.195 - 197, 2002/08
The fabrication status of Annular Coupled Structure (ACS) which was adopt for the 200-400MeV part of the injector linac is presented. The RF test of half-scale aluminum model is proceeding for high-power model fabrication. This result shows that the ACS structure has sensitivity to the RF contact with cavity and short-plates for RF measurement, and that the flatness of contact surface should be finished carefully. We also mention the error distribution of half-scale model frequencies and the RF properties about real scale aluminum models of buncher cavities.
Takeuchi, Suehiro
KEK Proceedings 2000-23, p.16 - 20, 2001/02
no abstracts in English
*
JNC TN1400 2000-007, 100 Pages, 2000/07
JNC-TN1400-2000-007.pdf:4.67MB
no abstracts in English
; ; *
JNC TY7430 2000-001, 57 Pages, 2000/03
JNC-TY7430-2000-001.pdf:2.17MB
no abstracts in English
; Ueno, Fumiyoshi
JNC TN9400 2000-017, 10 Pages, 2000/03
JNC-TN9400-2000-017.pdf:0.58MB
lt is difficult to get hold the behave of growth of cavity which nucleates in grain boudaly in experimental observation. lt is considerd that numerical simulation is effective for the grasp of behave of cavity growth, because it is able to grasp the microscopic behavior of internal material whici is hardly observation. We examine the factor that the diffusive ratio and the stress etc., affected growth of cavity on grain boundary with numerical simulation using diffusive equation. As the result, a following knowledge was obtained. (1)With dominant of grain boundary diffusion, the shape of cavity transitions from quasi-equilibrium to crac-like. ln other hand, with dominant of surface diffusion, cavity grows up with initial shape. (2)With dominate of grain boundary diffusion, it accelerates the growth rate of the cavity near the tip by grain boundaly diffusion induced stressing perpendicular to gain boundary (3)With dominant of surface diffusion, the distribution of chemical potential is uniformity on cavity surface. ln other hand, with dominant of grain boundary diffusion compare to that of surface diffusion, the gradient of chemical potential is increased at the tip of cavity.
Owada, Hitoshi*; Mihara, Morihiro; Iriya, Keishiro*; *
JNC TN8400 99-057, 43 Pages, 2000/03
Cementitious materials are considered as candidate materials for the geological disposal of high-level radioactive waste and TRU waste. As the pH and the Ca content of leachate from the cementitious materials are high, the host rock and the buffer-material would be degraded by the leachate in the long-term. Therefore, transport properties and parameters such as solubilities and distribution coefficients of radionuclides would be changed and affect the performance of the repository. In order to dissolve this "High pH plobrem", the use of a low alkalinity cement is considered for the disposal. In this study, we summarized the necessity of the low alkalinity cement, and developed the approach of the low alkalinization of cement. And, the following were carried out in this study : A leaching test of cement paste, a fluid test of the mortar and a installation test of the concrete to the trial structure. From the leaching test using the cement paste, we confirmed that we were able to obtain the low alkalinity cement (HFSC) by addition of pozzolanic materials such as silica-fume and flyash. From the result of the fluid test of the mortar, we chose the cement for the practicability evaluation. The practicability of low alkalinity concrete was evaluated by installation test to the trial structure.As a result of these examinations, we proved that the pH value of the leachate from the cementitious material was reduced by adding SF and FA to Portland cement. Simultaneously, SF and FA had to be added in order to obtain the good workability. In addition, workability and mechanical strength of the cement which SF and FA were added are almost equivalent to the ordinary Portland cement. The results shows that the HFSC has high practicability.
Sasamoto, Hiroshi; Yui, Mikazu; Randolph C Arthu*
JNC TN8400 99-074, 84 Pages, 1999/12
Hydrochemical investigation of Tertiary sedimentary rocks at JNC's Tono in-situ tests site indicate the groundwaters are: (1)meteoric in origin, (2)chemically reducing at depths greater than a few tens of meters in the sedimentary rock, (3)relatively old [carbon-14 ages of groundwaters collected from the lower part of the sedimentary sequence range from 13,000 to 15,000 years BP (before present)] (4)Ca-Na-HCO
type solutions near the surface, changing to Na-HCO type groundwaters with increasing depth. The chemical evolution of the groundwaters is modeled assuming local equilibrium for selected mineral-fluid reactions, taking into account the rainwater origin of these solutions. Results suggest it is possible to interpret approximately the "real" groundwater chemistry (i.e., pH, Eh, total dissolved concentrations of Si, Na, Ca, K, Al, carbonate and sulfate) if the following assumptions are adopted: (1)CO
concentration in the gas phase contacting pore solutions in the overlying soil zone = 10
bar, (2)minerals in the rock zone that control the solubility of respective elements in the groundwater include; chalcedony (Si), albite (Na), kaolinite (Al), calcite (Ca and carbonate), muscovite (K) and pyrite (Eh and sulfate). It is noted, however, that the available field data may not be sufficient to adequately constrain parameters in the groundwater evolution model. In particular, more detailed information characterizing certain site properties (e.g., the actual mineralogy of "plagioclase", "clay" and "zeolite") are needed to improve the model. Alternative conceptual models of key reactions may also be necessary. For this reason, a model that accounts for ion-exchange reactions among clay minerals, and which is based on the results of laboratory experiments, has also been evaluated in the present study. Further improvements of model considering ion-exchange reactions are needed in future, however.
